Get Setup

Amped Wireless Extender Setup

Nowadays, the top priority of most people is to get the fast speed of the internet connection for streaming and data transfer. For this, several people use the wireless router for fast speed but due to different hindrance it becomes difficult to get the WiFi signals in every corner of your home or office. To remove the dead zones from the area and to enhance the existing wireless signals, an amped wireless extender is used. It is the device that not only eliminates the dead spots but also improves the WiFi signal strength. Before proceeding further, you have to complete the amped wireless extender setup process. In this article, we have shared the simple instructions to resolve the issue facing during amped extender setup.

Guidelines to Login to the Amped Wireless Extender 

To update the extender’s settings, you first have to login to your Amped wireless range extender setup page. Once you login, you can change the wireless username, password, update the firmware and other things. Follow the below steps to login into Amped wireless extender:

Step 1: The first step is to connect the Amped wireless extender to the electrical socket and turn it on.

Step 2: After that, connect your extender with your device using an Ethernet cable. 

Step 3: Launch any internet browser of your choice from your system. Enter in the address bar of the internet browser. 

Note: If this web address does not work for you then you can access the login page by entering the IP address

Step 4: Now, a login web page displays on the screen.

Step 5: In the next step, you need to enter the username and password in the respective fields to access the setup page of your extender.

Step 6: Tap on the login button.

Step 7: Next, you have to follow the instructions displayed on the screen to complete the setup process.

Step 8: At last, you have to access the amped extender setup page and configure your device according to your requirements. 

Instructions for Amped Wireless Extender Setup

Walk through the below instructions for the amped wireless extender setup by using the web address:

Step 1: The first step is to connect WAN and modem using an Ethernet cable.

Step 2: After that, use the Ethernet cable to establish a connection between your computer to the internet ports of the router. 

Step 3: Switch off your router, modem and computer. Allow all of your devices to reboot and wait until they finish rebooting.

Step 4: Now, enter in the address bar of the web browser to access the control panel of the Amped extender login. You can also use the IP address to access the setup page.

Step 5: The Amped wireless extender login webpage displays on the screen. Enter the login credential details in the respective fields. 

Step 6: Next, the Amped wireless extender setup panel will display on the screen.

Step 7: Click on the “Start setup” to proceed further to the setup process.

Step 8: Choose the Automatic Configuration to allow the router wireless setting configuration 

Step 9: Select a new wireless network name for your home router. 

Step 10: Once the amped extender setup process is completed, a green tick mark will display.

Step 11: Finally, the Amped wireless extender will be set up. Now, you can connect any of your WiFi enabled devices to the Amped wireless range extender network. 

Amped Wireless Extender Setup through WPS Button

Here are the steps that you need to follow for amped extender setup by using the WPS button:

Step 1: Search for the WPS button on your Amped wireless extender device. You will easily find the WPS button on the backside of your extender.

Step 2: Once you find the WPS button, press it . 

Step 3: Within 2 minutes, press the WPS button on your router.

Step 4: Wait for sometime until the LED light on both of your devices will start blinking.

Step 5: Finally, your devices will start sync and the setup process is completed.